Kia Soul: Engine Electrical System
Kia Soul 2014-2019 PS Service Manual / Engine Electrical System
- Specification
- Tightening Torques
- Special Service Tools
- Troubleshooting
- Charging System
- Description
- On-vehicle Inpection
- Alternator Description
- Alternator Specification
- Alternator Components
- Alternator Circuit Diagram
- Alternator Removal
- Alternator Installation
- Alternator Disassembly
- Alternator Reassembly
- Alternator Inspection
- Battery Description
- Battery Specifications
- Battery Components
- Battery Adjustment
- Battery Removal
- Battery Installation
- Battery Vehicle parasitic current inspection
- Battery Cleaning
- Battery Troubleshooting
- Battery Sensor Description
- Battery Sensor Removal
- Battery Sensor Installation
- Battery Sensor Adjustment
- Cruise Control System
- Cruise Control
- System Block Diagram
- Trouble Symptom Charts
- Cruise Control Switch Component Location
- Cruise Control Switch Circuit Diagram
- Cruise Control Switch Inspection
- Cruise Control Switch Removal
- Cruise Control Switch Installation
- Ignition System
- Description
- On-vehicle Inspection
- Ignition Coil Description
- Ignition Coil Specification
- Ignition Coil Circuit Diagram
- Ignition Coil Removal
- Ignition Coil Installation
- Ignition Coil Inspection
- Spark Plug Description
- Spark Plug Specification
- Spark Plug Inspection
- Spark Plug Cleaning
- Spark Plug Removal
- Spark Plug Installation
- Starting System
Timing Chain Installation
1.
Dowel pin of crankshaft should be positioned at 3° in relation
to vertical center line.
2.
Align the TDC marks (A) of the CVVT ...
Specification
Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.79 ± 15％ [20°C (68°F)]
Secondary Coil Re ...
See also:
Intake Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuato ...
Spark Plug Inspection
[On vehicle inspection]
1.
Accelerate the engine to about 3,000 rpm 3 times or more.
2.
Remove the spark plug.
...
Receiver-Drier Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench
(A).
Tightening to ...