Kia Soul: Starter Relay Inspection - Starting System - Engine Electrical SystemKia Soul: Starter Relay Inspection

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Starting System / Starter Relay Inspection

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
55555
4.
Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
 Resistance
 Measure
30 - 87
 1MΩ or higher
 If there is continuity between the terminals, replace the relay.

5.
Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).
Terminal
 Resistance
 Measure
30 - 87
 1Ω or less
 If there is no continuity between the terminals, replace the relay.

6.
Install the starter relay.
7.
Install the fuse box cover.
    Starter Cleaning
    1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts with a cloth only. ...

    See also:

    Heater & A/C Control Unit (Manual) Component
    Connector Pin Function Connector Pin NO Function Connector Pin NO Function A 1 LOW B 18 IGN2 ...

    Driving at night
    Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may ...

    Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...