Kia Soul: Cruise Control Switch Inspection - Cruise Control System - Engine Electrical SystemKia Soul: Cruise Control Switch Inspection

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch Inspection

[Measuring Resistance]
1.
Disconnect the cruise control switch connector from the control switch.

2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
Terminal
Resistance
[kΩ ± 5%]
CANCEL
2 - 4
0.18
SET–
2 - 4
0.33
RES+
2 - 4
0.55
CRUISE
2 - 4
0.88

3.
If not within specification, replace switch.
[Measuring Voltage]
1.
Connect the cruise control switch connector to the control switch.

2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
Terminal
Voltage (V)
CANCEL
2 - 4
0.63 ~ 0.97
SET–
2 - 4
1.03 ~ 1.37
RES+
2 - 4
1.58 ~ 2.02
CRUISE
2 - 4
2.08 ~ 2.52

3.
If not within specification, replace switch.
    Cruise Control Switch Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group) 3. ...

    See also:

    Cross Member
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

    Antenna Coil Installation
    1. Install the coil antenna and connect the 6P connector. 2. Install the crash pad lower panel. 3. ...