Kia Soul: Alternator Removal
1. |
Disconnect the battery negative terminal.
|
2. |
Disconnect the air compressor connector (A) and the alternator
connector (B), and remove the cable from alternator "B" terminal (C).
|
3. |
Loosen the mounting bolts (A) and then, turn the adjusting bolt
(B) clockwise to loosen tension.
|
4. |
Remove the drive belt (A).
|
5. |
Remove the alternator brace assembly (A) after loosening the mounting
upper bolt (B) and brace mounting bolts (C).
|
6. |
Remove the alternator mounting low bolt (A), and then remove the
alternator.
|
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
See also:
Check battery and cables
Winter puts additional burdens on the battery system. Visually inspect the battery
and cables as described in section 7. The level of charge in your battery can be
checked by an authorized Kia dea ...
Runaway Arresting Device (RAD) Description and Operation
Description
RAD is installed on each battery module.
If the high voltage battery is swollen by cell overcharge, RAD cuts the ground of the main relay and the pre-charge relay.
If the cell is ove ...
Lighting control
The light switch has a Headlight and a Parking light position.
To operate the lights, turn the knob at the end of the control lever to one of
the following positions:
(1) OFF position
(2) Parki ...