Kia Soul: Specification - Engine Electrical SystemKia Soul: Specification

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Specification

Ignition System
Ignition Coil
Item
Specification
Primary Coil Resistance (Ω)
0.79 ± 15% [20°C (68°F)]
Secondary Coil Resistance (kΩ)
5.9 ± 15% [20°C (68°F)]

Spark plug
Item
Specification
Type
SILZKR6B10E
Gap
0.9 ~ 1.0 mm
(0.035 ~ 0.039 in.)

Condenser
Item
Specification
Capacitance (uF)
0.47 [1KHz]
Insulation resistance (MΩ)
1,000 [DC 500 V/1 Min]

Charging System
Alternator
ltem
Specification
Nominal output
13.5V, 110A
Speed in use
1,000 ~ 18,000 rpm
Voltage regulator
IC Regulator built in type
Regulator Setting Voltage
External mode
Refer to below graph
Internal mode
14.55 ± 0.3V
Temperature Gradient
External mode
0 ± 3 mV / °C 
Internal mode
-3.5 ± 2mV / °C
Target voltage data (COM)
Frequency (Hz)
115 ~ 500
Signal type
PWM
Voltage level (V)
High: 3.5 ± 0.2
Low: 1.5 ± 0.2
Electric load (FR)
Frequency (Hz)
250 ± 38
Signal type
PWM
Current limitation from vehicle (mA)
2.7 ~ 7.0

※ Regulator Setting Voltage (External mode)

Battery
▷ CMF60L-BCI
Item
Specification
Capacity [20HR / 5HR] (AH)
60 / 48
Cold Cranking Amperage (A)
550 (SAE) / 440 (EN)
Reserve Capacity (Min)
92

  
•
Model type description

•
Cold Cranking Ampere (CCA): Cold Cranking Amps is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
-
The rating is the number of amps a new, fully charged battery can deliver at -18 °C(-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 volts for a 12 volt battery.
-
The higher the CCA rating, the greater the starting power of the battery.
•
RESERVE CAPACITY (RC) : Reserve Capacity is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
-
The rating is the number of minutes a battery at 26.7 °C(80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 volts for a 12 volt battery.
-
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
Starting System
Starter
Item
Specification
Rated voltage
12 V, 0.9 kW
The number of pinion teeth
10
Performance
[No-load, 11.5 V]
Ampere
Max. 60 A
Speed
Min. 5,500 rpm

    Tightening Torques
    Item N.m kgf.m lb-ft Ignition coil mounting bolt 9.8 ~ 11.8 1.0 ~ 1.2 7.2 ~ 8.7 Spark plug 14.7 ~ 24.5 1.5 ~ 2. ...

    See also:

    Dynamic Damper Installation
    1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

    If you have a flat tire while driving
    If a tire goes flat while you are driving: 1.Take your foot off the accelerator pedal and let the vehicle slow down while driving straight ahead. Do not apply the brakes immediately or attempt to ...

    Variable Intake Solenoid (VIS) Valve. Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance betwe ...