Kia Soul: Starter Removal - Starting System - Engine Electrical SystemKia Soul: Starter Removal

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Starting System / Starter Removal

1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.
Remove the battery cable bracket (A) after loosening the mounting bolt (B).
4.
Disconnect the oil pressure switch connector (C).

5.
Disconnect the starter cable (B) from the B terminal on the solenoid then disconnect the connector from the S terminal (A).

6.
Remove the 2 bolts holding the starter, then remove the starter (A).

    Starter Installation
    1. Install in the reverse order of removal. Starter mounting bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) ...

    See also:

    Description
    The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce ...

    Cross Member
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...