Kia Soul: Starter Disassembly - Starting System - Engine Electrical SystemKia Soul: Starter Disassembly

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Starting System / Starter Disassembly

1.
Disconnect the M-terminal (A) on the magnet switchassembly.
2.
After loosening the 2 screws (A), detach the magnet switch assembly (B).
3.
Loosen the brush holder mounting screws (A) and the trough bolts (B).

4.
Remove the rear bracket assembly (A) and brush holder assembly (B).

5.
Remove the yoke assembly (A).
6.
Remove the packing (A), lever plate (B), lever (C), armature assembly (D).

  
Beware the direction of lever (A).
7.
Press the stopper (A) using a socket (B).

8.
After removing the stop ring (A) using stopper pliers (B).

9.
Remove the stop ring (B), stopper (A), overrunningclutch (C) and armature (D).

  
•
Using a suitable pulling tool (A), pull the overrunningclutch stopper (C) over the stop ring (B).

    Starter Installation
    1. Install in the reverse order of removal. Starter mounting bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) ...

    Starter Reassembly
    1. Reassemble in the reverse order of disassembly. ...

    See also:

    Seat Heater Switch Components and Components Location
    Components [First Row Seat] Connector Pin Information Pin No.Connector AConnector BConnector C1Illumination (+)GroundElectric compressor - interlock (+) 2Sensor REF (+5V)Sensor groundEle ...

    Rear Glass Repair procedures
    Removal     • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling A ...

    Torque Converter Control Solenoid Valve (T/CON_VFS). Circuit Diagram
    ...