Kia Soul: Starter Cleaning
Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Starting System / Starter Cleaning
1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
|
2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory and sol-vent
will wash lubrication from the clutch.
|
3. |
The drive unit may be cleaned with a brush moistened with cleaning
solvent and wiped dry with a cloth.
|
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...
Starter Relay Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the fuse box cover.
3.
...
See also:
Rear Door Belt Inside Weatherstrip Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).
...
Immobilizer system (if equipped)
Your vehicle is equipped with an electronic engine immobilizer system to reduce
the risk of unauthorized vehicle use.
Your immobilizer system is comprised of a small transponder in the ignition key ...
When Handling Refrigerant
1.
R-134a liquid refrigerant is highly volatile. A drop on the skin
of your hand could result in localized frostbite. When handling the
refrigerant, be sure to wear gl ...