Kia Soul: Parking Brake Lever. Adjustment
1. |
Remove the rear console cover (A).
|
1. |
Apply the brake pedal 20 times with the force of 10kgf after bleeding.
Then for the cable to settle in, apply the parking brake full stroke
more than 3 times.
|
2. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
3. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
4. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
5. |
Install the rear console cover.
|
Re-setting of the parking brake is necessary after overhauling
the caliper body, or if the brake calipers, housing, parking brake cable
or brake discs have been changed.
|
1. |
Remove the rear console cover (A).
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
5. |
Parking brake lever in the car must be in fully loosened position.
|
6. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
7. |
Check the wheels of their free operation.
|
8. |
Install the rear console cover.
|
Parking Brake Lever. Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Parking Brake Cable. Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
...
See also:
Side Impact Sensor (SIS). Description
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
в ...
Making a call using the Steering-wheel mounted controls
(1)
button : Mode changes each time the button pressed.
(2) VOLUME button : Raises or lowers speaker volume.
(3)
/
button :
RADIO mode
- Briefly press the key: Move to next or prev ...