Kia Soul: Parking Brake Lever. Installation
Kia Soul 2014-2019 PS Service Manual / Brake System / Parking Brake System / Parking Brake Lever. Installation
1. |
Install the parking brake lever assembly (A).
|
2. |
Install the parking brake cable (B).
|
3. |
Apply a coating of the specified grease to each sliding parts
(A) of the ratchet plate or the ratchet pawl.
|
4. |
Install the parking brake cable adjuster, then adjust the parking
brake lever stroke by turning adjusting nut (A).
|
5. |
Release the parking brake lever fully, and check that parking
brakes do not drag when the rear wheels are turned. Readjust if necessary.
|
6. |
Make sure that the parking brakes are fully applied when the parking
brake lever is pulled up fully.
|
7. |
Reconnect the connector (A) of parking brake switch.
|
8. |
Install the floor console.
(Refer to Body - "Floor console")
|
Parking Brake Lever. Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
...
Parking Brake Lever. Adjustment
Parking Brake Lever Stroke Adjustment
1.
Remove the rear console cover (A).
1.
Apply the brake pedal 20 times with the force of 10kgf af ...
See also:
Winter driving
Severe weather conditions in the winter result in greater wear and other problems.
To minimize the problems of winter driving, you should follow these suggestions: ...
Knock Sensor (KS). Description and Operation
Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knoc ...
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...