Kia Soul: Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected.
When pressing any button (or turning any knob) except AUTO button while automatic operation, the functions not selected will be controlled automatically.
1. Start the engine.
2. Set the mode to the desired position.
3. Set the temperature control to the desired position.
4. Set the air intake control to the outside (fresh) air position.
5. Set the fan speed control to the desired speed.
6. If air conditioning is desired, turn the air conditioning system on.
Press the AUTO button in order to convert to full automatic control of the system.
- Mode selection
- Temperature control
- Air intake control
- Fan speed control
- Air conditioning
- Blower OFF
- Climate information screen selection
Automatic heating and air conditioning
1. Push the AUTO button. It is indicated by AUTO on the display. The modes, fan
speeds, air intake and air-conditioning will be controlled automatically by temperature
setting.
2.Set the temp ...
Mode selection
The mode selection button controls the direction of the air flow through the
ventilation system.
Refer to the illustration in the “Manual climate control system”.
The air flow outlet port is ...
See also:
High Voltage Shut-off Procedures
High Voltage Shut-off Procedure
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
syst ...
Schematic Diagrams
Circuit Diagram
...
Repair procedures
Replacement
1.
Remove the cap (A), the nuts and the wiper arm (B).
Tightening torque :
22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)
2.
Remove the glue from both ends (A) of the ho ...