Kia Soul: Water pump Installation - Cooling System - Engine Mechanical SystemKia Soul: Water pump Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Water pump Installation

1.
Install the new gasket and water punp(A).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

2.
Install the water pump pulley (A).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

  
Tighten the bolts diagonally when installing.
3.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
4.
Fill with engine coolant.
5.
Start engine and check for leaks.
6.
Recheck engine coolant level.
    Water pump Inspection
    1. Check each part for cracks, damage or wear, and replace the coolant pump assembly if necessary. 2. Check the bearing for damage, abnorma ...

    Water pump Troubleshooting
    Symptoms Possible Causes Remedy Coolant leakage • From the bleed hole of the water pump Visually ...

    See also:

    Advanced lighting speaker
    The advanced lighting speaker that lights around the front speaker is adjusted by turning the knob as follows. 1. OFF : The light turns off. 2. MUSIC : The light blinks or changes shade accord ...

    Piston and Connecting Rod Components
    1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    Basic Service Symbols
    There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. Symbol Meaning ...