Kia Soul: Mode selection
The mode selection button controls the direction of the air flow through the ventilation system.
Refer to the illustration in the “Manual climate control system”.
The air flow outlet port is converted as follows:
Vent mode (B, D)
Air flow is directed toward the upper body and face. Additionally, each outlet can be controlled to direct the air discharged from the outlet.
Vent-Floor mode (B, D, C, E)
Air flow is discharged towards the face and floor.
Floor mode (C, E,
A, D)
Most of the air flow is directed to the floor, with a small amount of the air being directed to the windshield and side window defroster.
Floor/Defrost mode (A, C, E, D)
Most of the air flow is directed to the floor and the windshield with a small amount directed to the side window defrosters.
Defrost mode (A, D)
Most of the air flow is directed to the windshield with a small amount of air directed to the side window defrosters.
Instrument panel vents
The outlet port can be opened or closed separately using the thumbwheel.
Also, you can adjust the direction of air delivered from these vents using the vent control lever as shown.
Manual heating and air conditioning
The heating and cooling system can be controlled manually by pushing buttons
other than the AUTO button. In this case, the system works sequentially according
to the order of buttons selected.
Wh ...
Temperature control
The temperature will increase to the maximum (HI) by pushing the button ().
The temperature will decrease to the minimum (Lo) by pushing the button ().
When turning the knob, the temperature will ...
See also:
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the clutch switch connector (A).
...
Schematic Diagram
Canister
The Canister is filled with charcoal and absorbs evaporated fuel vapor
from the fuel tank. The gathered fuel vapor in canister is drawn into the intake
manifold by the ECM/PC ...
Brake/clutch fluid
Checking the brake/clutch* fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the ...