Kia Soul: Hazard Lamp Switch Installation - Lighting System - Body Electrical SystemKia Soul: Hazard Lamp Switch Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Installation

1.
Install the hazard switch in the center airvent assembly.
2.
Connect the connector and install the center airvent assembly.
3.
Connect the negative (-) battery terminal.
    Hazard Lamp Switch Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the center airvent assembly (A). ...

    Rheostat Inspection
    1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad ...

    See also:

    Power Seat Control Switch Inspection
    1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the po ...

    Rear Door Latch Replacement
    1. Remove the rear door module. (Refer to Rear Door - "Rear Door Module") 2. Remove the rear door outside handle base (A) by p ...

    Wheel. Hub nut tightening sequence
    Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)    ...