Kia Soul: Front Impact Sensor (FIS). Removal - SRSCM - RestraintKia Soul: Front Impact Sensor (FIS). Removal

Kia Soul 2014-2019 PS Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Removal

  
•
Removal of the airbag must be performed according to the precautions / procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the air duct (A). [Left side only]
3.
Disconnect the front impact sensor connector (A).

4.
Loosen the mounting bolt and then remove the front impact sensor (B) and extension harness.
    Front Impact Sensor (FIS). Components
    ...

    Front Impact Sensor (FIS). Installation
       • Do not turn the ignition switch ON and do not connect the battery cable while replac ...

    See also:

    Coolant Replacement And Air Bleeding
       Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...

    Cooling Fan Components
    1. Cooling fan mounting retainer 2. Torque washer 3. Cooling fan 4. Fan motor 5. Cooling fan shroud 6. Cooling fan resistor ...

    Cooling System Refilling And Bleeding
       Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...