•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Take care not to scratch the body surface.
|
|
1. |
After loosening the mounting clip and screws, then remove the
front mud guard (A).

|
2. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
•
Put on gloves to protect your hands.
...
•
Put on gloves to protect your hands.
...
See also:
Battery Sensor Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation
bolt:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 l ...
Pressure Source Unit Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.
...
Illuminated ignition switch
Whenever a front door is opened, the ignition switch will illuminate for your
convenience, provided the ignition switch is not in the ON position. The light will
go off immediately when the ig ...