Kia Soul: Notes on the suggested use of the Tire Mobility Kit - If you have a flat tire (tire mobility kit, if equipped) - What to do in an emergencyKia Soul: Notes on the suggested use of the Tire Mobility Kit

Kia Soul 2014-2019 PS Owner's Manual / What to do in an emergency / If you have a flat tire (tire mobility kit, if equipped) / Notes on the suggested use of the Tire Mobility Kit

  • Park your car at the side of the road so that you can work with the Tire Mobility Kit away from moving traffic.
  • To be sure your vehicle will not move, even when you're on fairly level ground, always set your parking brake.
  • Only use the Tire Mobility Kit for sealing/inflation passenger car tires. Only punctured areas located within the tread region of the tire can be sealed using the tire mobility kit.
  • Do not use on motorcycles, bicycles or any other type of tires.
  • When the tire and wheel are damaged, do not use Tire Mobility Kit for your safety.
  • Use of the Tire Mobility Kit may not be effective for tire damage larger than approximately 0.24 in (6 mm). Please contact the nearest Kia dealership if the tire cannot be made roadworthy with the Tire Mobility Kit.
  • Do not use the Tire Mobility Kit if a tire is severely damaged by driving run flat or with insufficient air pressure. • Do not remove any foreign objects such as nails or screws that have penetrated the tire.
  • Provided the car is outdoors, leave the engine running. Otherwise operating the compressor may eventually drain the car battery.
  • Never leave the Tire Mobility Kit unattended while it is being used.
  • Do not leave the compressor running for more than 10 min. at a time or it may overheat.
  • Do not use the Tire Mobility Kit if the ambient temperature is below - 22°F (-30°C).
    Introduction
    With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture. The system of compressor and sealing compound effectively and comfortably seals most punctures in a passenger ...

    Components of the Tire Mobility Kit
    0. Speed restriction label 1. Sealant bottle and label with speed restriction 2. Filling hose from sealant bottle to wheel 3. Connectors and cable for the power outlet direct connection 4. Hol ...

    See also:

    Rear Hub - Carrier Inspection
    1. Check the hub for cracks and the splines for wear. 2. Check the brake disc for scoring and damage. 3. Check ...

    Front Impact Sensor (FIS) Description and Operation
    Description The Front Impact Sensors (FIS) are installed in the Front End Module (FEM). These remote sensors are used to detect acceleration due to a collision at the mounting location. The p ...

    Cooling Fan Inspection
    Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...