Kia Soul: Components of the Tire Mobility Kit - If you have a flat tire (tire mobility kit, if equipped) - What to do in an emergency - Kia Soul 2014-2019 PS Owner ManualKia Soul: Components of the Tire Mobility Kit

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Owner Manual / What to do in an emergency / If you have a flat tire (tire mobility kit, if equipped) / Components of the Tire Mobility Kit

0. Speed restriction label

0. Speed restriction label

1. Sealant bottle and label with speed restriction

2. Filling hose from sealant bottle to wheel

3. Connectors and cable for the power outlet direct connection

4. Holder for the sealant bottle

5. Compressor

6. On/off switch

7. Pressure gauge for displaying the tire inflation pressure

8. Screw cap for reducing tire inflation pressure

9. Hose to connect compressor and sealant bottle or compressor and wheel

Connectors, cable and connection hose are stored in the compressor housing.

WARNING - Expired sealant

Do not use the Tire sealant after the sealant has expired (i.e. pasted the expiration date on the sealant container). This can increase the risk of tire failure.

WARNING - Sealant

  • Keep out of reach of children.
  • Avoid contact with eyes.
  • Do not swallow.

Strictly follow the specified sequence, otherwise the sealant may escape under high pressure.

    Notes on the suggested use of the Tire Mobility Kit
    Park your car at the side of the road so that you can work with the Tire Mobility Kit away from moving traffic. To be sure your vehicle will not move, even when you're on fairly level g ...

    Using the Tire Mobility Kit
    1. Detach the speed restriction label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too ...

    See also:

    Power Door Lock Switch Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim ...

    Cylinder Block Inspection
    1. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Using a soft brush and solvent, th ...

    Inspection
    1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...