Inspection
[Fuel pump]
1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Check that motor operates properly when applying battery voltage to terminals 2 and 4 of fuel pump connector (A).
Pin No. |
discription |
1 |
Fuel sender signal |
2 |
Fuel pump (+) |
3 |
Fuel sender ground |
4 |
Fuel pump (-) |
|
[Fuel sender]
1. |
Turn ignition switch OFF and disconnect the negative (-)battery cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.
Pin No. |
discription |
1 |
Fuel sender signal |
2 |
Fuel pump (+) |
3 |
Fuel sender ground |
4 |
Fuel pump (-) |
|
4. |
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position |
Resistance (Ω) |
Capacity (ℓ) |
E |
197 ~ 203 |
4.3 |
1/2 |
64.2 ~ 68.2 |
26.4 |
F |
6 ~ 10 |
51.3 |
|
Removal
1. |
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
|
3. |
Remove the fuel pump service cover (A).
|
4. |
Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
|
5. |
Disconnect the fuel feed tube quick connector (C) and the vapor tube quick-connector (D).
|
6. |
Remove the plate cover (E) after removing the mounting bolts.
|
7. |
Remove the fuel pump from the fuel tank.
|
Installation
1. |
Install in the reverse order of removal.
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).
|
Fuel pump plate cover mounting bolt :
2.0 ~ 3.0 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2lb-ft)
|
|
Removal
1.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pres ...
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
...
See also:
Repair procedures
Fuel Pressure Test (Low pressure system)
1.
Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedu ...
Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane
number ((R+M)/2) of 87 (Research Octane Number 91) or higher.
Your new vehicle is designed to obtain maximum performa ...
Multi box
To open the box, pull the lever and the cover will open.
Push down the cover to close. ...