Kia Soul: Cooling Fan Removal and Installation
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Removal and Installation
Cooling fan assembly
1. |
Disconnect the battery negative terminal.
|
2. |
Remove the air duct (A).
|
3. |
Separate the filler neck (A) from the radiator upper member assembly.
|
4. |
Disconnect the radiator reservoir hose (A).
|
5. |
Remove the hood lower latch.
(Refer to Body - "Hood Latch")
|
6. |
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - “Engine Room Under Cover”)
|
7. |
Separate the ATF cooler hoses (A) from the holders on the cooling
fan assembly. (A/T only)
|
8. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
9. |
Remove the headlamps.
(Refer to Body Electrical System - "Head Lamps")
|
10. |
Remove the radiator upper member assembly (A).
|
11. |
Disconnect the cooling fan connector (A).
|
12. |
Remove the cooling fan (A) from the vehicle.
|
13. |
Install in the reverse order of removal.
|
Resistor
1. |
Disconnect the wire harness connector (A) and the fan motor connector
(B).
|
2. |
Remove the resistor (A) from the cooling fan shroud.
|
3. |
Install in the reverse order of removal.
|
Cooling Fan Disassembly
1. Remove the cooling fan (A) from the cooling fan assembly. 2. Disconnect the fan motor connector (A) from the resistor. ...See also:
Tail Gate Latch Replacement
•
Put on gloves to protect your hands.
...
Camshaft Position Sensor (CMPS). Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification:
Refer to “Wave Form”
...
Online factory authorized manuals
The following publications are available on www.KiaTechinfo.com at no charge. ...