Kia Soul: Auto Light Sensor Inspection
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Inspection
In the state of IGN1 ON, when the multi function switch module detects
auto light switch on, tail lamp relay output and head lamp low relay output
are controlled according to auto light sensor's input.
If IGN1 ON, The BCM monitors the range of this supply and raises up
a failure as soon as the supply’s voltage is out of range. Then this failure
occurs and as long as this is present, the head lamp must be turned on without
taking care about the sunlight level provided by the sensor.
This is designed to prevent any head lamp cut off when the failure
occurs during the night.
Auto Light Switch Inspection
1. Operate the auto light switch, then check for continuity between terminals of multi-function switch connector. ...Auto Light Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor (A) from crash pad upper side ...See also:
Removal
1.
Drain the brake fluid through the bleed plug (A).
• ...
Outside rearview mirror
Be sure to adjust the mirror angles before driving.
Your vehicle is equipped with both left-hand and right-hand outside rearview
mirrors. The mirrors can be adjusted remotely with the remote switch ...
Answering Calls
Answering a Call
Answering a call with a Bluetooth® Wireless Technology device connected will
display the following screen.
To accept the call, press
key on the steering wheel while the call ...