Kia Soul: Auto Light Sensor Removal
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Removal
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the photo & auto light sensor (A) from crash pad upper
side by using screw (-) driver.
|
3. |
Remove the auto light connector (B).
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light se ...Auto Light Sensor Installation
1. Reconnect the auto light connector. 2. Install the auto light sensor. ...See also:
Rear Seat Belt Buckle Replacement
[LH]
1.
Detach the rear seat belt lower anchor (C) by pushing the lock
pin (B) of center mini buckle (A) with flat-tip driver.
2.
...
Specifications
Item
Specification
Master cylinder
Type
Fixed seal
Cylinder I.D.
Ø 20.64 mm (0.813 in)
Piston stroke
45 В± 1 mm ...
Thermostat Components
1. Water inlet fitting
2. Thermostat
...