Kia Soul: Transmitter Inspection
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Keyless Entry / Transmitter Inspection
| 1. |
Check that the red light flickers when the door lock or unlock
button is pressed on the transmitter.
|
| 2. |
Remove the battery (A) and check voltage if the red light
doesn't flicker.
|
| 3. |
Insert the battery (A) into the tester (09954-2P100).
|
| 4. |
Push the test button and If "0.00" is displayed on screen,
it means that the battery voltage is 2V or less.
|
| 5. |
If "L" is displayed on screen, it means that the battery is
low power and it needs to replace.
|
| 6. |
To prevent the discharge of electricity, turn the tester power
off.
|
| 7. |
Replace the transmitter battery with a new one, if voltage
is low power then try to lock and unlock the doors with the transmitter
by pressing the lock or unlock button five or six times.
|
| 8. |
If the doors lock and unlock, the transmitter is O.K, but
if the doors don't lock and unlock, register the transmitter code,
then try to lock and unlock the doors.
|
| 9. |
If the doors lock and unlock, the transmitter is O.K, but
if the doors don't lock and unlock, replace the transmitter.
|
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16
pins) in driver side crash pad lower panel, turn the power on GDS.
...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector (A).
3.
Measure resistance bet ...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be ...
Inspection
Check it by the procedure below to see if the function of the ECM
is normal.
1.
Turn the ignition key to the "ON" position.
...