Kia Soul: Inspection - Keyless Entry - Body Electrical SystemKia Soul: Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Keyless Entry / Inspection

Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
Disconnect the connectors from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
5.
Check for continuity between the terminals in each switch position according to the table.
Rear Door Lock Module Inspection
1.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
2.
Remove the rear door module.
(Refer to Body - "Rear Door Module")
3.
Disconnect the connectors from the actuator.
4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
5.
Check for continuity between the terminals in each switch position according to the table.
Tailgate Lock Module Inspection
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Disconnect the 4P connector from the actuator.
3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Tailgate Open Switch
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Disconnect the connector from the actuator.
3.
Check for continuity between the terminals in each switch position according to the table.
Hood Switch
1.
Disconnect the connector (A) and bolts from the hood switch.
2.
Check for continuity between the terminals and ground according to the table.
    Component Location
    1. Hood switch 2. BCM & RF receiver 3. Key warning switch 4. Front door lock actuator & switch 5. Rear door lock actuator & switch 6. Tailgate ...

    Transmitter Inspection
    1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the batt ...

    See also:

    60,000 miles or 48 months
    ❑ Inspect air conditioning compressor, air conditioner refrigerant and performance (if equipped) ❑ Inspect cooling system *1 ❑ Inspect drive belt *4 (First, 60,000 miles or 72 ...

    Rear Door Inside Handle Replacement
    1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Loosen the rear door inside handle mounting screws ( ...

    Transaxle Oil Temperature Sensor. Installation
    1. Install in the reverse order of removal.    • ...