Kia Soul: Transmitter Code Registration (Using GDS) - Keyless Entry - Body Electrical SystemKia Soul: Transmitter Code Registration (Using GDS)

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Keyless Entry / Transmitter Code Registration (Using GDS)

1.
Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS.

2.
Select the vehicle model and then do "CODE SAVING"

3.
After selecting "CODE SAVING" menu, button "ENTER" key, then the screen will be shown as below.

4.
After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps 1 to 4 and then code saving is completed.

    Transmitter Inspection
    1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the batt ...

    See also:

    Exhaust Manifold Removal and Installation
    1. Remove the engine cover. 2. Disconnect the battery negative terminal. 3. Disconnect the front and rear oxyg ...

    Cruise control system
    1. Cruise indicator 2. Cruise set indicator The cruise control system allows you to program the vehicle to maintain a constant speed without pressing the accelerator pedal. This system is des ...

    Tilt and telescopic steering
    Tilt and telescopic steering allows you to adjust the steering wheel before you drive.You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel sho ...