•
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the front impact sensor.
|
|
1. |
Install the new front impact sensor.
|
2. |
Tighten the front impact sensor (B) mounting bolt.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)
|

|
3. |
Connect the front impact sensor connector (A).
|
4. |
Install the air duct. [Left side only]
|
5. |
Reconnect the battery negative cable.
|
6. |
After installing the Front Impact Sensor, confirm proper system
operation:
A. |
Turn the ignition switch ON the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
•
Removal of the airbag must be performed according to the
precautions / procedures de ...
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
See also:
Inhibitor Switch. Description
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
...
Automatic transaxle operation
The automatic transaxle has 6 forward speeds and one reverse speed. The individual
speeds are selected automatically, depending on the position of the shift lever.
NOTICE
The first few shifts on a ...
Adding equipment to or modifying your air bagequipped vehicle
If you modify your vehicle by changing your vehicle's frame, bumper system, front
end or side sheet metal or ride height, this may affect the operation of your vehicle's
air bag system.
A ...