Kia Soul: TJ Joint Components
[LH] |
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly |
9. Snap ring 10. TJ housing 11. TJ circlip |
[RH] |
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ housing |
13. TJ circlip |
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
TJ Joint Replacement
•
Special grease must be applied to the driveshaft joint.
Do not substitute with anoth ...
See also:
Rear Seat Assembly Repair procedures
Replacement
[Rear seat back assembly]
1.
Detach the rear seat belt lower anchor (C) by pushing the lock pin (B) of center mini buckle (A) with flat-tip driver.
2.
Fold the rear seat back as ...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring Spec.)
1
GND
DC Ground
...
Inlet Temperature Sensor Description and Operation
Description
Inlet temperature sensor is installed on the No.8 module of
high voltage battery and it detects the inner air temperature of
battery. The operation of cooling fan depends on the inl ...