Kia Soul: TJ Joint Replacement - Driveshaft Assembly - Driveshaft and axleKia Soul: TJ Joint Replacement

Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Replacement

  
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
1.
Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the BJ circlip (B) from the TJ housing (A).

3.
Remove both boot bands from the TJ housing.

4.
Remove the TJ circlip (A).

  
Make alignment marks on spider roller assembly (A), TJ housing (B), and shaft spline (C) to aid reassembly.

5.
Remove the snap ring (A) from the shaft.

6.
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).

7.
Clean the spider assembly.
8.
Remove the TJ boot (A).
  
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).

    TJ Joint Components
    [LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Snap ring 10. TJ h ...

    TJ Joint Inspection
    1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...

    See also:

    Clean air(if equipped)
    When the ignition switch is in the ON position, the clean air function turns on automatically. Also, the clean air function turns off automatically, when the ignition switch turns to the OFF posi ...

    Electronic stability control (ESC)
    The Electronic Stability control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC appl ...

    Radiator Removal and Installation
    1. Disconnect the battery negative terminal. 2. Remove the air duct (A). 3. Separate the filler neck (A ...