Kia Soul: Power Door Lock Actuators Inspection
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
5. |
Check for continuity between the terminals in each switch
position according to the table.
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
5. |
Check for continuity between the terminals in each switch
position according to the table.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the connector from the actuator.
|
3. |
Check for continuity between the terminals in each switch
position according to the table.
|
1. |
Disconnect the connector (A) and bolts from the hood switch.
|
2. |
Check for continuity between the terminals and ground according
to the table.
|
Component Location
1. Driver power window main switch
2. BCM (Body Control Module)
3. Door lock switch
4. Front door lock actuator & switch
5. Rear door lock actuator & ...
Power Door Lock Switch Diagnosis With GDS
1.
The BCM can be diagnosed by using the GDS. The BCM communicates
with the GDS which then displays inputs and outputs along with codes.
It will be able to ...
See also:
Fuel Pump. Repair procedures
Inspection
[Fuel pump]
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
...
SRS Control Module (SRSCM). Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
60,000 miles or 48 months
❑ Inspect air conditioning compressor, air conditioner refrigerant and performance
(if equipped)
❑ Inspect cooling system *1
❑ Inspect drive belt *4 (First, 60,000 miles or 72 ...