Kia Soul: Knock Sensor (KS). Knock Sensor (KS). - Engine Control System - Engine Control / Fuel SystemKia Soul: Knock Sensor (KS). Knock Sensor (KS).

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Knock Sensor (KS). Knock Sensor (KS).

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
3.
Disconnect the knock sensor connector (A).

4.
Remove the mounting bolt (A), and then remove the sensor (B) from the cylinder block.

Installation

  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.

Knock sensor mounting bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)

    Knock Sensor (KS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Heated Oxygen Sensor (HO2S). Description and Operation
    Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

    See also:

    Cooling Fan Description
    [Air conditioning type] The cooling fan operates in 2 stages (HIGH/LOW). The engine control module (ECM) controls the cooling fan according to the coolant temperature, vehicle speed and A ...

    Mode selection
    The mode selection button controls the direction of the air flow through the ventilation system. Refer to the illustration in the “Manual climate control system”. The air flow outlet port is ...

    Steering gear rack, linkage and boots
    Inspection 1. Check the steering wheel free road. (1) Turn the steering wheel so that the front wheels can face straight ahead. ...