Kia Soul: Heated Oxygen Sensor (HO2S). Description and Operation
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S). Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Manifold Catalytic Converter. The sensor
output voltage varies in accordance with the air/fuel ratio.
The sensor must be hot in order to operate normally. To keep it hot, the
sensor has a heater which is controlled by the ECM via a duty cycle signal.
When the exhaust gas temperature is lower than the specified value, the heater
warms the sensor tip.
55555
Knock Sensor (KS). Knock Sensor (KS).
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the engine room under cover.
(Re ...
Heated Oxygen Sensor (HO2S). Specifications
Specification
HO2S [Bank 1/Sensor 1]
Item
Specification
Heater Resistance (Ω)
2.4 ~ 4.0 [20°C(68°F)]
HO2S [Bank 1/Sensor 2]
A/F Ra ...
See also:
Registering your vehicle in a foreign country
If you plan to register your vehicle in a foreign country, you should confirm
that it conforms to the regulations in that country. Even if you successfully register
the vehicle in a foreign countr ...
Tachometer
The tachometer indicates the approximate number of engine revolutions per minute
(rpm).
Use the tachometer to select the correct shift points and to prevent lugging
and/or over-revving the engi ...
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...