Kia Soul: Inspection - Ignition Switch Assembly - Body Electrical SystemKia Soul: Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Ignition Switch Assembly / Inspection

1.
Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column.

2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.

    Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad ...

    See also:

    Rear Door Belt Inside Weatherstrip Repair procedures
    Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the rear door belt inside weatherstrip (A). 3. Install in the reverse order of removal. ...

    Repair procedures
    Refrigerant System Service Basics • Since the electric compressor uses high-voltage, POE oil with high volumetric resistivity should be used. • Do not use the same A/C recovery ...

    Line Pressure Control Solenoid Valve. Removal
       Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...