Kia Soul: Removal - Ignition Switch Assembly - Body Electrical SystemKia Soul: Removal

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Ignition Switch Assembly / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
4.
Remove the wiper switch.
(Refer to "Multifunction switch")
5.
Remove the ignition switch after loosening disconnecting the ignition switch 6P connector (A).
55555
6.
Remove the ignition switch assembly (A) after loosening the mounting bolts.
7.
If it is necessary to remove the key lock cylinder (A), it is in the order as below.
(1)
Disconnect the key warning/ immobilizer connector (A)
(2)
Turn the key to ACC (A).
(3)
Remove the key lock cylinder (B) while pushing the removal/ installation button under the key cylinder (A).
    Inspection
    1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. ...

    Installation
    1. Install the key lock cylinder. 2. Install the key warning and immobilizer connector. 3. ...

    See also:

    Teaching Procedures
    1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. ...

    [CVVT System Mode]
    (1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

    Forward and rearward
    To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked i ...