Kia Soul: Cooling Fan Disassembly - Cooling System - Engine Mechanical SystemKia Soul: Cooling Fan Disassembly

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Cooling Fan Disassembly

1.
Remove the cooling fan (A) from the cooling fan assembly.

2.
Disconnect the fan motor connector (A) from the resistor.

3.
Remove the fan motor (A) from the cooling fan shroud.

Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Assemble in the reverse order of disassembly.
    Cooling Fan Removal and Installation
    Cooling fan assembly 1. Disconnect the battery negative terminal. 2. Remove the air duct (A). 3. Se ...

    Cooling Fan Inspection
    Fan Motor 1. Disconnect the fan motor connector from the resistor. 2. Connect the battery voltage to the "+" terminal and ...

    See also:

    Rear Center Seat Belt Retractor Replacement
       • When installing the belt, make sure not to damage the retractor. ...

    Door Scuff Trim Component Location
    1. Front door scuff trim 2. Rear door scuff trim ...

    Fuel Tank Pressure Sensor (FTPS). Specifications
    Specification Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -6.67 (-0.068, -26.8) 0.5 0 2.5 +6.67 (0.068, 26.8) ...