Kia Soul: Brake Pedal. Installation - Brake System - Brake SystemKia Soul: Brake Pedal. Installation

Kia Soul 2014-2019 PS Service Manual / Brake System / Brake System / Brake Pedal. Installation

1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A) securely.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

3.
Tighten the bolt (A) securely in dash panel.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

4.
Install the snap pin (A) and clevis pin (B).

  
•
Before installing the pin, apply the grease to the clevis pin.
•
Use a new snap pin whenever installing.
5.
Install the stop lamp switch securely.
6.
Connect the stop lamp switch connector (A).

7.
Adjust the brake pedal height and free play.
8.
Check the brake pedal operation after installing the brake pedal.
9.
Install the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
10.
Reconnect the battery negative cable.
    Brake Pedal. Inspection
    1. Check the bushing for wear. 2. Check the brake pedal for bending or twisting. 3. Check the brake pedal retur ...

    Brake Switch. Removal
    1. Disconnect the brake switch connector (A). 2. Pull the locking plate (A) as indicated by the arrow. 3. ...

    See also:

    Side repeater light bulb Type B replacement (if equipped)
    If the light bulb is not operating, have the vehicle checked by an authorized Kia dealer. ...

    Temperature Control Actuator Inspection
    1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

    Favorites
    Press the key  Select [Favorites] 1) Saved favorite contact : Connects call upon selection 2) To add favorite : Downloaded contacts be saved as favorite. To save Favorite, contac ...