Kia Soul: Inhibitor Switch. Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Soul 2014-2019 PS Service ManualKia Soul: Inhibitor Switch. Removal

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Removal

1.
Place the shift lever into the "N" position.
2.
Disconnect the battery negative (-) cable.
3.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air cleaner")
4.
Disconnect the inhibitor switch connector (A).
5.
Remove the shift cable mounting nut (B).

6.
Remove the manual control lever (B) and the washer after removing a nut (A).

7.
Remove the inhibitor switch (A) after removing the bolts (2ea).

    Inhibitor Switch. Inspection
       • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contam ...

    Inhibitor Switch. Installation
    1. Check that the shift lever is placed in the "N" position 2. Install the inhibitor switch (A). ...

    See also:

    Front Impact Sensor (FIS). Description
    The Front Impact Sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of ...

    Transmitter precautions
    ✽ NOTICE The transmitter will not work if any of following occur: The ignition key is in the ignition switch. You exceed the operating distance limit (about 30 feet [10 m]). The batter ...

    Starter Installation
    1. Install in the reverse order of removal. Starter mounting bolt: 49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft) ...