Kia Soul: Inhibitor Switch. Installation - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: Inhibitor Switch. Installation

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Installation

1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
  
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.

3.
Install the manual control lever (A).
  
Lightly tighten the manual contorl lever nut (B) so that necessary adjustments can be made.

4.
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
5.
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque:
A : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
B : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the SST (09480-A3800) from the hole.
7.
Connect the inhibitor switch connector (A).
8.
Install the shift cable by tightening nut (B).
  
Lightly tighten the shift cable mounting nut (B) so that necessary adjustments can be made.

9.
Push the shift cable to the arrow "F" to eliminate free play and then tighten the nut (A) with the specified torque.
Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

10.
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
11.
Connect the battery negative (-) cable.
    Inhibitor Switch. Removal
    1. Place the shift lever into the "N" position. 2. Disconnect the battery negative (-) cable. 3. Remo ...

    Shift Lever. Components
    1. Shift lever knob & boots aseembly 2. Shift lever assembly 3. Shift cable assembly 4. Shift cable retainer 5. Shift cable brakcet 6. Manual control lever ...

    See also:

    Washer fluid
    Checking the washer fluid level Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solve ...

    Telemetics Unit (TMU) Inspection
    1. After replacing the TMU unit, access Dealer Engineering Mode in head unit. (Refer to MTS system - "TMU Dealer Engineering Mode") ...

    Torque Converter Control Solenoid Valve (T/CON_VFS). Description
    Torque converter control solenoid valve (T/CON) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the torque converter. ...