Kia Soul: Wheel. Hub nut tightening sequence - Tires/Wheels - Suspension SystemKia Soul: Wheel. Hub nut tightening sequence

Kia Soul 2014-2019 PS Service Manual / Suspension System / Tires/Wheels / Wheel. Hub nut tightening sequence

Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

  
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Run-out
 Aluminum
 Steel
Radial mm(in.)
 Below 0.3(0.0118)
 Below 1.4(0.0551)
Lateral mm(in.)
 Below 0.3(0.0118)
 Below 0.9(0.0354)

3.
If measured value exceeds the standard value, replace the wheel.
    Tire Installation
    1. Apply tire soap or lubrication to the top and bottom tire beads. 2. To fit the bottom bead, position the valve at the 5 o’clock pos ...

    Alignment. Front wheel alignment
       When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always ...

    See also:

    Troubleshooting
    Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

    Alternator Installation
    1. Install in the reverse order of removal. 2. Adjust the alternator belt tension after installation. (Refer to Engine Mechanical ...

    Steering Column and Shaft. Replacement
    1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...