Kia Soul: Alignment. Front wheel alignment - Tires/Wheels - Suspension SystemKia Soul: Alignment. Front wheel alignment

Kia Soul 2014-2019 PS Service Manual / Suspension System / Tires/Wheels / Alignment. Front wheel alignment

  
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead.
Prior to wheel alignment, steering column is approximately in tilt mid position.
Toe


B - A > 0: Toe in (+)
B - A < 0: Toe out (-)

Toe adjustment
1.
Loosen the tie rod end lock nut.
2.
Remove the bellows clip to prevent the bellows from being twisted.
3.
Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount.

Toe-in
Total : 0.1° ± 0.2°
Individual : 0.05° ± 0.1°

4.
When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque.

Tightening torque:
49.0 ~ 53.9 N.m (5.0 ~ 5.5 kgf.m, 36.2 ~ 39.8 lb-ft)

Camber and Caster
Camber and Caster are pre-set at the factory, so they do not need to be adjusted. If the camber and caster are not within the standard value, replace or repair the damaged parts and then inspect again.

Camber angle : -0.5° ± 0.5°


Caster angle : 5.1° ± 0.5°

    Wheel. Hub nut tightening sequence
    Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)    ...

    See also:

    Troubleshooting
    Problem Symptoms Table Use the table below to help you find the cause of the problem. The numbers indicate the priority of the like cause of the problem. Check each part in order. ...

    Information
    Press the key Set [ Info] through the TUNE knob or key. Displays information of the current song. ❈ Press the key to turn off info display. ...

    Brake Pedal. Installation
    1. Pre-tighten the bracket fixing bolt (A) in dash panel. 2. Install the brake booster and brake pedal member fixing nuts (A) secur ...