Kia Soul: TJ Joint Installation
Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Installation
1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
4. |
Install the both boot band.
|
5. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
6. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
7. |
Install the Front Driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
8. |
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
|
TJ Joint Inspection
1. Check the spider assembly for roller rotation, wear or corrosion. 2. Check the groove inside the joint case for wear or corrosion ...Dynamic Damper Components
1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly ...See also:
SEEK
Press
the key
Shortly pressing the key (under 0.8 seconds): select previous or next channel.
Pressing and holding the key (over 0.8 seconds): continuously move to previous
or next chann ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wi ...
Parking brake
Inspect the parking brake system including the parking brake lever (or pedal)
and cables. ...