Kia Soul: Removal
1. |
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air Cleaner")
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical System -"Battery")
|
3. |
Disconnect the speed sensor connector (A) and back up lamp switch
(B).
|
4. |
Remove the ground (A).
|
5. |
Remove the clutch tube bracket bolt (B).
|
6. |
Remove the control cable.
|
7. |
Remove the transaxle upper mounting bolt (B-2ea) and the starter
mounting bolt (A-2ea).
|
8. |
Install the engine support fixture.
|
9. |
Remove the cover (A).
|
10. |
Remove the transaxle mounting bracket bolts (A).
|
11. |
Remove the transaxle support bracket (A).
|
12. |
Remove the under cover and side cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
13. |
Remove the drive shaft assembly.
(Refer to Driveshaft and axle - "Front Driveshaft")
|
14. |
Remove the air guide (A).
|
15. |
Remove the drive shaft cover (A).
|
16. |
Remove the clutch release cylinder assembly (B) after removing
the bolts (A).
|
17. |
Remove the roll rod bracket (C) after removing bolt (A,B).
|
18. |
Remove the mounting bolt (A, B) after supporting the transaxle
by a jack.
|
19. |
Remove the transaxle while slowly lower the jack.
|
Components
1. Control shaft complete 2. Back-up lamp switch 3. Control cable bracket 4. Speed sensor 5. Transaxle case ...Installation
When replacing a clutch housing or transaxle assembly, the wiring bracket should be installed in accordance with the clu ...See also:
Specifications
Item
Specifications
Working voltage
DC 12V
Operating force
Initial position : 0.25 ± 0.15N(0.025 ± 0.015kg,
0.056 ± 0.034lb)
F ...
Ignition Coil Inspection
1.
Measure the primary coil resistance between terminals (+) and
(-).
Standard value:
0.79Ω ± 15%
...
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...