Kia Soul: Inspection
Front Door Lock Module Inspection
1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Remove the front door module.
(Refer to Body - "Front Door Module")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
5. |
Check for continuity between the terminals in each switch
position according to the table.
|
Rear Door Lock Module Inspection
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Remove the rear door module.
(Refer to Body - "Rear Door Module")
|
3. |
Disconnect the connectors from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
5. |
Check for continuity between the terminals in each switch
position according to the table.
|
Tailgate Lock Module Inspection
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the 4P connector from the actuator.
|
3. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
Tailgate Open Switch
1. |
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
|
2. |
Disconnect the connector from the actuator.
|
3. |
Check for continuity between the terminals in each switch
position according to the table.
|
Hood Switch
1. |
Disconnect the connector (A) and bolts from the hood switch.
|
2. |
Check for continuity between the terminals and ground according
to the table.
|
Component Location
1. Hood switch 2. BCM & RF receiver 3. Key warning switch 4. Front door lock actuator & switch 5. Rear door lock actuator & switch 6. Tailgate ...Transmitter Inspection
1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the batt ...See also:
Closing the fuel filler lid
1. To install the cap, turn it clockwise until it “clicks” once. This indicates
that the cap is securely tightened.
2. Close the fuel filler lid and push it in lightly making sure that it is se ...
Components
1. TPMS Receiver
2. TPMS Sensor (FL)
3. TPMS Sensor (RL)
4. TPMS Sensor (RR)
5. TPMS Sensor (FR)
...
Vehicle stability management (VSM)
This system provides further enhancements to vehicle stability and steering responses
when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient
of friction between ...