Kia Soul: Inspection - Clutch Switch - Clutch SystemKia Soul: Inspection

Kia Soul 2014-2019 PS Service Manual / Clutch System / Clutch Switch / Inspection

Signal Circuit Inspection
1.
Check clutch switch pull-up voltage
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect clutch switch connector.
(3)
IG KEY "ON".
(4)
Measure the voltage between signal terminal of clutch switch harness connector and chassis ground.

Specification : 11.5V ~ 13.0V

2.
Check open in clutch switch signal circuit
(1)
IG KEY "OFF", ENGINE "OFF".
(2)
Disconnect clutch switch connector and ECM connector.
(3)
Check continuity between signal terminal of clutch switch harness connector and ECM harness connector.

Specification : Continuity ( below 1.0Ω )

Ground Circuit inspection
1.
IG KEY "OFF", ENGINE "OFF".
2.
Disconnect clutch switch connector.
3.
Check continuity between clutch switch harness connector terminal 3 and chassis ground.

Specification : Continuity ( below 1.0Ω )

Component Inspection
1.
Remove the clutch & ignition lock switch.
2.
Rotate the clutch switch lever to the direction of the arrow to check the continuity.

Switch : ON ↔ OFF
Clutch pedal position
Clutch switch
Released
Continuity
Fully pressed
Open

    Description
    - Clutch swtich is connected to clutch pedal and transmits clutch operation state to ECM. - TCM detects the clutch operation through the clutch s ...

    Removal
    1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the clutch switch connector (A). ...

    See also:

    Rear Door Side Weatherstrip Replacement
    1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) ...

    Check tire pressure
    You can check the tire pressure in the assist mode on the cluster. - Refer to “LCD mode” on page 4-54. Tire pressure is displayed 1~2 minutes later after driving. If tire pressure is not ...

    Rear Door Inside Handle Repair procedures
    Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Loosen the rear door inside handle mounting screws (A). 3. Using a flat-tip screwdriver (B), pull up ...