Kia Soul: Inhibitor Switch. Inspection - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: Inhibitor Switch. Inspection

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch. Inspection

  
•
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Power Circuit Inspection
1.
Disconnect the Inhibitor switch connector.
2.
Ignition KEY "ON"" & Engine "OFF".
3.
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Signal Circuit Inspection
1.
Connect the Inhibitor switch connector.
2.
Ignition KEY "ON" & Engine "OFF".
3.
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
Signal Code Table
　
 P
 P-R
 R
 R-N
 N
 N-D
 D
Signal "1"
 12V
 12V
 0
 0
 0
 0
 0
Signal "2"
 0
 12V
 12V
 12V
 0
 0
 0
Signal "3"
 0
 0
 0
 12V
 12V
 12V
 0
Signal "4"
 0
 0
 0
 0
 0
 12V
 12V

    Inhibitor Switch. Circuit Diagram
    ...

    Inhibitor Switch. Removal
    1. Place the shift lever into the "N" position. 2. Disconnect the battery negative (-) cable. 3. Remo ...

    See also:

    Replacement
    1. Uplift the vehicle with lift. 2. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. 3. Check the removed fuse; replace it if it is blown. To remove ...

    Drive shafts and boots Inspection
    1. Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage. ...