Kia Soul: Front Seat Assembly Replacement - Front Seat - Body (Interior and Exterior)Kia Soul: Front Seat Assembly Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Replacement

1.
Loosen the front seat assembly mounting bolts (A).
Tightening torque :
34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)
[Front]

[Rear]
2.
Remove the front seat assembly (A).
3.
Disconnect the seat buckle connector (A), seat warmer & power seat connector (B), SAB connector(C), PODS connector (D).
[Driver's]

[Passenger's]
4.
Install in the reverse order of removal.
  
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
    Front Seat Assembly Component Location
    1. Front seat assembly ...

    Front Seat Shield Outer Cover Component Location
    1. Front seat shield outer cover ...

    See also:

    SS-B Solenoid Valve(ON/OFF). Description
    SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

    Front Stabilizer Bar Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt (A) and then disco ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling the cover up. 3. Check the removed fuse; replace it if it is blown. To remo ...