Kia Soul: Emergency Fastening Device (EFD). Installation - Seat Belt Pretensioner - RestraintKia Soul: Emergency Fastening Device (EFD). Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD). Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the emergency fastening device with bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the emergency fastening device connector (A).
5.
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
6.
Insert the seat belt to the emergency fastening device (A).

  
Make sure the lock pin is connected in properly.
7.
Reconnect the battery negative cable.
8.
After installing the emergency fastening device, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Emergency Fastening Device (EFD). Removal
    1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. To remove the emergency fastening ...

    SRSCM
    ...

    See also:

    Compressor Installation
    1. Make sure the compressor (A) mounting bolt with the correct length is screwed in. Tighten the mounting bolts with the specified tightening order. ...

    Vehicle certification label
    The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...

    Circuit Diaram
    ...