Kia Soul: Component Replacement after Deployment
Kia Soul 2014-2019 PS Service Manual / Restraint / Component Replacement after Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Trouble Code list for repairing of the related DTCs.
|
When the front airbag(s) deployed after a collision, replace the following
items.
- |
SRSCM
|
- |
Deployed airbag(s)
|
- |
Seat belt pretensioner(s)
|
- |
Emergency fastening device
|
- |
Front impact sensors
|
- |
SRS wiring harnesses
|
- |
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the
following items.
- |
SRSCM
|
- |
Deployed airbag(s)
|
- |
Side impact sensor(s) for the deployed side(s)
|
- |
SRS wiring harnesses
|
After the vehicle is completely repaired, confirm the SRS airbag system
is OK.
- |
Turn the ignition switch ON, the SRS indicator should come on
for about 6 seconds and then go off.
|
Special Service Tools
Tool Name / Number Illustration Description Deployment tool 0957A-34100A Used for deploying airbag Deployment adapter 0957A- ...Precautions
General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbag ...See also:
Audio Remote Control Circuit Diagram
...
Flywheel Removal and installation
1.
Remove the manual tranaxle.
(Refer to Manual Transaxle System - "Manual Transaxle ")
2.
Remove the flywheel (A).
...
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)
...