•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the center fascia panel
(A).
|
2. |
Disconnect the A/C & heater controller connectors (A).
|
3. |
Install in the reverse order of removal.
• |
Make sure the connector are connected in properly.
|
• |
Replace any damaged clips.
|
|
|
1. Center fascia panel
...
1. Crash pad lower panel
...
See also:
Power Seat Control Switch Installation
1.
Install the power seat control switch after connecting the
connector.
2.
Install the front seat shield outer cover.
...
Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly.
WARNING
Open the hood after turning off the engine on a flat surface, shifting the
shift lever to the P (Park) ...
Auto Light Sensor Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper
side ...