Kia Soul: Brake Switch. Removal
| 1. |
Disconnect the brake switch connector (A).
|
| 2. |
Pull the locking plate (A) as indicated by the arrow.
|
| 3. |
Turn brake switch 45В° counterclockwise and remove it.
|
Brake Pedal. Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Brake Switch. Inspection
1.
Check the stop lamp switch.
(1)
Connect a circuit tester to the connector of stop lamp
switch, and check whether or not there is ...
See also:
Replacement
1.
Uplift the vehicle with lift.
2.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
...
Line Pressure Control Solenoid Valve. Specifications
Direct control VFS[LINE Pressure]
▷ Control type : Normal high type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)
Current va ...
Rear Torsion Beam Axle Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...