Kia Soul: Speakers Inspection - Audio - Body Electrical SystemKia Soul: Speakers Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Audio / Speakers Inspection

1.
Troubleshooting for Speaker
(1)
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.
55555
(2)
Case Troubleshooting
No.
 Case
 Inspection/Remedy
1
 Trembling sound
1.
Before replacing the speaker, inspect that the mounting screw is installed normally.
2.
After re-installing the speaker, verify that no trembling sound is heard.
3.
When hearing a trembling sound again, replace the speaker with new one.
2
 Noise
1.
Check if the wiring connector is connected normally. If not, reconnect the wiring connector.
2.
In case of radio static, check if there is a noise from CD player.
3.
When a noise is heard on turning radio and CD on, replace the speaker with new one.
  
In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement.
3
 Poor working
 Inspection of the wiring connection between the battery and the speaker
1.
Before replacing the speaker, inspect the wiring and connections in the speaker circuit.
2.
Check the supplying power to the speaker and the resistance, and then inspect the sound quality.
3.
If the speaker works poorly, replace it with new one.

  
When handling the speaker :
-
Dropping or rough handling of the speaker can cause damage.
-
Be careful not to spill water or oil on the speaker.
-
Caution when dealing with speaker because the diaphragm is paper and can be easily torn by impact and external force.
-
Electrical mishandling of speakers is not covered by manufacturers warranty.
    Audio Unit Inspection
    1. Check the specified value of AVN head unit connectors in specified condition. Standard type Connector A No. Name Terminal Descript ...

    Speakers Removal
       Put on gloves to protect your hands.    ...

    See also:

    Auto Light Sensor Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the photo & auto light sensor (A) from crash pad upper side ...

    Roller Blind Removal
    1. Open the roller blind using the panorama sunroof switch.    ...

    Remote keyless entry system operations
    Lock (1) 1.Close all doors, engine hood and tailgate. 2.Press the lock button(1). 3.All doors and tailgate will lock. The hazard warning lights will blink once. 4.If the lock button is pressed o ...